AutoZeroAir

A wireless conversion kit for the Sienci AutoZero touch plate. The battery module clips to the side of the plate, with two spring pins pressing on it and nothing to drill or solder. Each touch reaches the controller over the air, and the module wakes when you pick the plate up and sleeps for months on a USB-C charge.

The AutoZero touch plate is not included. This kit is for a Sienci AutoZero you already own.

Needs the ncSender Wireless Receiver, sold separately below. It works with most CNC controllers, as long as the controller has a probe input and can supply 5 to 24 V to the receiver.

Orders outside the USA ship without the battery. Lithium cells can't travel that route, so you fit one locally: a 3.7 V 150 mAh LiPo (size 352025). YDL Battery sells the right one. The link opens with YDL's default options, which won't fit. Change them to these before you order:

  • Connector: Molex 1.25-2P 51021-0200
  • Polarity: Standard (metal side facing you, contacts up, wires down: red left, black right)
  • Wire length: 30 mm
  • NTC: No NTC (standard)

YDL's minimum order is 4 batteries.

$75.00

Pre-order. Pre-orders are open for the first batch. Expected December 2026. Your card is charged when you order.

Add to your order
ncSender Wireless Receiver

See it in action

Reviews

No reviews yet.

Write a review
Not published. Used to confirm a purchase.

Show it fitted to your machine if you can. Anything you attach appears with your review once we have read it.